Re: [MittleiderMethodGardening] How high for water storage tank
Pounds per square inch (PSI) x 2.31 = Feet head (of water)
30 psi = 69.3 feet ~ 69' 3"
40 psi = 92.4 feet ~ 92' 5"
You will need to add this much height to overcome the pressure loss in 60
feet of pvc pipe :
SCH 40 PVC: 12.8 feet
SCH 80 PVC: 14.7 feet
Add 2' of height per gal/min of flow rate for Head Loss:
Note:
9 gal/min = Max flow rate for SCH 80 pipe
11 gal/min = Max flow rate for SCH 40 pipe
Plus add 1' of height per coupler, 2' per 'ell', and 5' per 'tee'
Finally, you'll need to add additional height to give you the additional
water pressure you'll need based on the equation at the beginning of this
reply.
If you intend to use a different type of pipe, please let me know and I'll
be happy to post the results for that type.
Michael
----- Original Message -----
From: "Chuck G" <cgordon2005@tampabay.rr.com>
To: <MittleiderMethodGardening@yahoogroups.com>
Sent: Sunday, September 12, 2010 2:29 PM
Subject: [MittleiderMethodGardening] How high for water storage tank
> How high must a water storage tank be to get about same pressure (30-40
> psi) as delivered by a city water system? And if impossible to get
> about same pressure, how high must water storage tank be to give
> sufficient pressure for a run of maybe 60 feet of 3/4 inch PVC. (these are
> good questions for a water engineer - any in the house? - JK)
>
> And should pipe be drilled with #57 bit for first 30 feet and then with
> 1/16 inch bit for remaining length? (Yes - JK) Or should pipe be drilled
> with 1/16 inch the full length? Or even bigger for after 30 feet?
>
> Thanks for answer
>
> Chuck G
>
>
>
>
> ------------------------------------
>
> Yahoo! Groups Links
>
>
>
7:28 PM
|
|
This entry was posted on 7:28 PM
You can follow any responses to this entry through
the RSS 2.0 feed.
You can leave a response,
or trackback from your own site.
0 comments:
Post a Comment